TM SAIGA-12 optic mount minimalistic

Replaces the original shotgun rib and uses the existing rear mount to place a short low profile picrail for people looking to mount optics and don't want big chonky rails / handguards.

Install:

• remove the shotgun rib, but don't unscrew the rear base (protip, put on some loctite while you're at it)
• place the new printed piece inside the rear base and use an small grubscrew or pin to secure it
• if needed you can use an thin cable binder to extra secure the mount around the top gastube as seen on the photo's

The model has been made pretty tight so make sure your machine is dialed in! you can always file down some sides if needed.

-- content --

• saiga optic rail 3 slots (short)
• saiga optic rail 5 slots (long)