Guitar LED Neon

Knowledge of soldering is highly recommended but not required. 

Boost MeBoosts and Profile ratings are always welcome. Thank you!

 Feel free to follow my Instagram. Link in profile. Thank you! 

1. Print the three plates
2. Melt the seams together with soldering iron. ( you can use glue but its not even close to the same strength as melting together. Trust me i've done several of these) Be sure you use a wider tip and make sure its clean otherwise it will leave dirt in the plastic.
3. Cut the plug end off of LED strip and push remainder of cord through hole in back as seen below
5. Wire directly into dimmer switch or plug. (I highly recommend using solder) be sure to cover each wire with electrical tape or heat shrink.
6. Sit back and enjoy your awesome neon guitar

• LED lights I use but any 5mm wide rope light will work. https://a.co/d/1iF47ig
• This power supply will work https://a.co/d/ipyuH4a
• I like to use these dimmers but not required https://a.co/d/21EmuOf