Fallout Stimpack (Slightly Overengineered)

Boost MeMembership

Hello Fallout Fans, here's my stimpack design which I hope you enjoy as much as I do! This is a multi-part print and everything screws together for a very satisfying result.

 

A slightly overengineered stimpack design, this screws together without needing any glue.  Two dial faces are included, embossed and engraved.  The faces and vial have been painted but this can be printed in a single color and painted by hand.

 

As featured in this video where iengzeh prints this out in white and then paints and weathers it for an amazing result!

 

For the inner vial there is an AMS version with black lines, but you can just print using red and white/translucent/luminous and swap colors around layer 180.

 

The only the main body needs supports for the arms, be very careful removing the supports as the tabs break easily. Aside from that, a piece of red and blue filament are added between the holes in the arms between the tabs and the arm, and the gauge. I left a smaller hole for those wanting to use wire.

 

Raw files are available in the downloads section, please like and share your results!