WWE compatible Steel Cage

I spent days and days perfecting the sizing and fit of this Steel Cage and I am so glad I did, it looks freakin awesome and is so simple to assemble and reassemble (for easy storage) + once built it is really strong too

It can be 75% assembled too so leaving a side open or not putting the top half of a side on which means the kids can still access it to have fun… (it can still be fully played with built of course… it is worth highlight that it just doesn't have to be :)

Has a functioning door, flaf 'top' rails so that your Superstar figures can stand atop ready to launch in to the ring

I recommend that you use a large printer A1 bed size and up will be okay…  as the rails are 30cm tall

print the plate with rails laying flat with tree support

print the fence that has the door with tree support
 

The strength using PLA is fine and that is with ZERO infill, yep literally no infill is required, the profile is set to print at 15% infill, but you don't have too…

You are gonna bring joy to some kids 100% (or yourself if you are a big kid)

_Enjoy_

PS: any problems assembling, send me a message

parts to print are:

WWE-End-Bottom Corner Clip (x4) (fit these first, they just clip in between the ring canvas and bottom turnbuckle
WWE- Corner Bar - top ropes (x4) (fit these second)
WWE - Middle Bar (x4) - slide the 1 x Cage entrance x and 15 Fences in to the slots, then slide in to the Corner Bar slots all the way down to the Corner Clip (do one side at a time, you'll fell the strength come together
WWE - Fence (x15)
WWE - Bottom Door Entrance (do the same as the Fences to fit this part)
WWW - Top Rail (x4), once all the Fences are slotted in, the whole cage will have a lot of tension that pulls everything nice and even and very strong :)
assemble the Top Rails and it will allow for the WWE wrestlers to stand a top ready for some flying elbows :)

Here is a ladder too :) WWE Superstars compatible Ladder by leek78 - MakerWorld
Here are some Steel Stairs too :) WWE Steel Stairs by leek78 - MakerWorld

Assembly instructions probably not needed by many, but just in case… here is a Youtube video (excuse the accent :) )