Guitar Humidifer

A humidifier for acoustic and classical guitars.

This humidifier requires a sponge, which should be cut to size (approximately 5 x 7 x 0.9 cm). When using the humidifier, the sponge should be wet, but excess water squeezed out, so it doesn't drip inside the guitar. The humidifier is placed in between the 3rd and 4th string, and pushed in so that the strings are inside the notches on either side of the humidifier. This holds it in place.

Features

• String holder notches, allowing the guitar strings to hold the humidifier in place
• Strategically placed ventilation holes to ensure adequate humidification
• Simple push-fit attachment for the lid, resistant to breakage

Printing Notes

• The included print profile should have all the required settings
• Seam is placed in the back
• Variable layer height for the top layers of the humidifier body
• Supports were only used for the string holder notches
• I used Matte PLA