Honeycomb Bravo Additional Levers Display/Holder

A display/holder for the Honeycomb Bravo Throttle Quadrant to hold additional throttle, prop, mixture, flap, and spoiler levers. Also offers storage in the base and under the arch for other pieces. 30x pieces total to make it easier to print.

Post Processing: The lever pegs will need to be glued into place; there should be a decent amount of wiggle room to allow for either hot glue, super glue, or PLA Gloop. The Seam covers will also need to be glued into place once the arch is inserted into the top base. They are to cover the seam between the top base and arch. ENSURE the arch is centered in the top base well before gluing.

Instructions:

Storage Base: Print it in the orientation of use. No supports needed.

Top Base: Print it in the orientation of use. No supports needed.

Arch: Print on its edge for ease of printing. Minimal supports are needed on the base of the sliding mechanism to ensure it fits together well.

Lever Pegs: 24x. Print upside down with the fat side down. That is the only flat surface.

Seam Cover: Used to cover the seam between the Top Base and the Arch. Can be printed flat. I printed it so that it is standing up to match the layer lines of the Top Base. If printing standing up, brim highly recommended.

Honeycomb Logo: Printed with the side opposite the letters on the build plate with a color change at layer 15.