N20 motor mount

A simple attatchment housing for an n20 motor. Holes support M3 screws, centre of the holes is approx 20mm appart. An n20 motor should snap into this housing and provide a snug fit with no movement to keep the motor securely in place. 
(Motor supported is 24mm long and 11.9mm wide approx, rear is open bar one small holding tab to allow most kind of rear interfaces including makerworld n20 motor)

In the print profile it does use some support material, you cant stand it up but in the past ive noticed this can deform the screw holes and seems to take longer to print. 

Usage :

Place the shaft through the hole first then align the body and push in. Motor should then snap into place. to remove push on the rear portion that sticks out.