Illinois Central Railroad Coasters

Illinois Central Railroad Coasters

 

These coasters are 89mm square and 3mm thick.

 

This print profile worked just fine on my X1C

  I used an initial layer line with of  .03 due to the small lines. You might be able to get good results using the .05, I'm not sure. 
If you have issues printing the .03 I would suggest maybe using a little bit of Aqua Net hair spray on the plate.
 

I always apply a self-adhesive cork backing to my coasters. I have listed a link to them on Amazon. You will have to trim them. https://a.co/d/0PjaF1i

 

Take a look at my other railroad and non-railroad coasters and clocks at https://makerworld.com/en/@railimages

 

Boost MeBoost Me (for free)
I would appreciate it if you could rate my model and profile and if you really like it, leave a BOOST.

It would be greatly appreciated!

Thank you and enjoy!