Anova Compatable Sous Vide Clamp

*** ensure supports are on to avoid print failure***
**V2 is now up. It refines the sious vide clamp a little but also gives options to print a bucket clip.**


Original description (plate 1 only) - This is a repair part I made for the Anova compatible Sous Vide A3.2-120V-US. The file includes ONLY the part shown in white. It replaces very near the original part but is slightly simplified. I recommend printing in PETG or PCTG (shown here) to make sure it doesn't soften/sag while cooking. If you disassemble your old bracket you can use the existing screws to attach this ring to the existing screw clamp. Simply remove the four screws and slide off the old part and slide on the new printed part. The file should have inner/outer bring and support for the screw interface but feel free to remove/modify them if you feel like you don't need them. I like the insurance. I did not have to do any trimming and the screw holes all lined up nicely. I have no idea if this will fit on other Anova compatible models but would be slightly skeptical (please let me know if it does). If there are any updates needed, just let me know. Lastly, please ignore the hideous layer line in the picture. I had a filament tangle and couldn't get to it until the print had cooled significantly and I don't reprint functional prints unless function is impacted. Hope this helps someone out. 

Updates on V2 (Plates 2-4) - I added bucket clips as some people seemed to need them. There are two options of where to hang the unit on a bucket rim. If the bucket clip strongest printed on side and use the original screws to attach the original device clamp or the printed version (best printed on its back). Some people have reported print failures from app due to lack of supports, which I think I've fixed now but send me a message if I haven't. I'll look again. Happy slow cooking.