skyward pried 元神天空之傲

Boost Me

名称：元神天空之傲（skyward pried） 

 

 

Specifications:

规格：

剑身1.3m，由于剑身与剑柄的比例过大，同时出于声光电套件（Motion-Activated Sound and Light Props Kit）的限制，本模型结构上做了一定的修改，可能套件安装会比较难，请耐心与小心。

剑柄保证一圈会有3-4层墙，以保证其强度。同时为了保证结构的完整性护手部分为一体打印，请小心拆支撑。

The sword body is 1.3m long. Due to the large ratio of the sword body to the hilt and the limitations of the Motion Activated Sound and Light Props Kit, some modifications have been made to the structure of this model. The installation of the kit may be difficult, so please be patient and careful.

The sword hilt is guaranteed to have 3-4 layers of walls in one circle to ensure its strength. At the same time, to ensure the integrity of the structure, the handguard part should be printed as a whole. Please be careful when removing the support.

 

前期准备：

Preliminary preparation:

1：胶水

1: Glue

2：拆支撑的工具2: Tools for dismantling supports

3：一根棍子（推荐不必须）3: A stick (recommended not necessary)

 

安装：

*一根棍子的作用是方便从剑柄处的小孔把内壁支撑捣碎，以方便拆除以及连接线的安装。

Installation:

*The function of a stick is to facilitate the crushing of the inner wall support through the small hole at the hilt of the sword, for easy removal and installation of connecting wires.

*胶水是出于强度考虑。

关键是如图处，如果材料太脆，一定要用胶水粘贴以增加强度。

*Glue is used for strength considerations.

The key is as shown in the picture, if the material is too brittle, it must be glued together to increase strength.