Tesla (Model 3/Y 2025+) Vent Air Freshener Holder

Boost MeHi there! If you have a spare boost, I’d be so grateful for your support. While bigger creators often get lots of attention, boosting smaller creators like me truly makes a big difference. Your boost would help me keep sharing unique, niche models for everyone to enjoy. Thank you so much for considering it—it means the world! 🙏💖

New Tesla Model Y / Model 3 (Highland / Juniper) Front Vent Air Freshener Clip Holder

Adds a Clip-On Mount Point for Standard Air Fresheners

 

MembershipCommercial License Membership For Resellers Available

 

For Highland/Juniper Models only: for older Models Vent Clip Holder see https://makerworld.com/en/models/592007-tesla-model-3-y-air-freshener-holder#profileId-513673

 

Tesla’s elegant front vent design lacks a place to clip on traditional air fresheners.

 

This 3D printable insert is custom-designed for the front vents of the Tesla Model Y and Model 3 2025+ (Highland/Juniper).

It slides securely into the horizontal vent slot and provides a rigid tab for clip-on air fresheners to attach to — enabling you to use popular vent-mounted scents like Axe, Febreze, Glade, or Little Trees that otherwise wouldn’t fit.

 

🧩 Features:

• Installs securely in the front air vents — no tools or adhesives needed
• Provides a mounting point for most standard clip-on air fresheners
• Designed not to block airflow
• Clean, minimal appearance that blends seamlessly into the interior
• Printed with fuzzy skin enabled to match the soft texture of Tesla's fabric dash accent
• 2 Print Profiles Available:
  • Recommended - Optimized for TPU 95A to ensure a secure yet gentle fit
  • Alternative - PETG, If you dont have TPU available you can use PETG (needed for heat resistance and slight flexibility)

🖨️ Recommended Print Settings:

• Material: TPU (High Flow 95A recommended) or PETG
• Layer Height: 0.2 mm
• Walls: 2 (not more as it will get too rigid)
• Infill: 15% for TPU / 10% For PETG
• Supports: Not required
• Orientation: Flat side down as shown
• Fuzzy Skin: Enabled on visible surface (to mimic fabric texture: Point Distance 0.25mm / Thickness 0.08mm)

Easy Install:
 

 

💡 Pro Tip: Install one on each vent for dual-scent setups or better scent spread.

 

Boost MeHi there! If you have a spare boost, I’d be so grateful for your support. While bigger creators often get lots of attention, boosting smaller creators like me truly makes a big difference. Your boost would help me keep sharing unique, niche models for everyone to enjoy. Thank you so much for considering it—it means the world! 🙏💖