The Impo-psicle Firecracker Passthrough

BEFORE YOU PRINT ******* VERSION 2 IS NOW UPLOADED******* CHECK MY PROFILE ********

 

Prime tower IS enabled. The prime tower is for even colour changes, if you do not want the prime tower simply DISABLE it in print settings. 

 

Not just another Impossible Passthrough. Introducing the “Impo-psicle” Passthrough Firecracker Edition!

Looking for something new? Unique? Not been done before? well here it is!

the Original Popsicle Passthrough Fidget with melting base for your desktop, or anywhere you choose!

This is a Print in Place model. Optemized for lowest material usage, but you can up the infill % if you choose.

The print can get dicey with small first layer contact points, so I've added an outer brim to the popsicle only, and slowed down the speed for the stick part.

I recommend using the profile provided to print the model for this reason.

Tested to print up to 12 at once with 12 bases on another plate.

Popsicle modeled using Makerlab Image to 3d AI

Important Information- Due to the orientation of the print, some have experienced breakages at the popsicle stick. To make it a little stronger please note there is a "USE BEAM INTERLOCKING" option in the slicer under the ADVANCED section in the “OTHERS” tab . This adds more colour changes (3 per colour I believe) but makes the colour swap areas a bit stronger.

Follow me for more to come! Several more Impo-psicles are already waiting to be tested!

 

.2mm Layer

2 Walls

5% Rectilinear Infill

Only 3 colour changes for minimal waste!

No Support

Print in Place

Outer Brim (Popsicle Only)

Tolerances might be tight at first on the popsicle, but will loosen with use.

Base has a tight fit at first but will also loosen with use.

 

Boost MeKindly leave a boost if you like my work. Every little bit helps toward materials for testing, showing interest in the model type so I make more like it, keeps my morale up, and most importantly shows me you enjoy my work. Thank you!