Adjustable graphic card holder - Ryzen

Min. height 62 mm

Max height 111 mm

 

You just press the logo into the base and it's ready.

 

2 version logo, see the other print profile.

 

Instructions:

I put the objects on separate trays because different layer heights and ironing and filement changes.

 

Bulid plate 1

Main item

0,2 mm layer height

No ironing

 

Build plate 2

Logo

0,2 mm layer height

Ironing on top surfaces (I set 30mm/s and 30% (I think the correct setting depends on the printer and the type of filament)

Minimal support at the bottom (5x5 mm)

 

Build plate 3

Inner rod

0,12 mm layer height

No ironing

 

Boost MeBoost me if you like it! Thank you! ;)

 

An 8x2 mm magnet can be placed in the bottom.

On a flat surface, push the magnet in to make it nice and flat. Minimal superglue can go into the hole, but it's not necessarily necessary.

 

If you spray a little PTFE or similar lubricant inside the thread, the rod will rotate much better.

 

 

High-speed printing is not recommended due to fine details.

 

It probably won't work if resized.

 

Check out my other uploads and download and print them. ROG, Nvidia, Aorus, Intel, AMD, TUF, Sapphire, and many more.

 

!!! Make sure the print speed and temperature and cooling are set correctly for your printer and the filament you are using. And the build plate should be clean. !!!