Plug in the cable and bend the connectors. If possible solder or glue connection so that it does not slip out.Add the small gear and clip motor into positionSnug correct fitInsert the longer pin on the left side (Tip: you can sand down the knurl on the top side a bit) and the shorter smooth one on the ride side. Insert gears as shown, use the translucent gear on the left side.Put the gear cover abovePush all the way down! It should be even with the frameMount the printed gearAssemble the integrated switch: 1. Slide the small “switch plate” into the slot 2. Insert the switch. The switch must catch the small plate as shown. 3. Screw M2,5x6 and also add a M2,5x6 screw from the bottom, as well.Slide the battery connectors inBattery connectors should look like thisBend the contacts at the end slightly upwards with a flat objectConnect the cables (Tip: You can connect the cables the other way to make the train run in the other direction)Push edge cover above the gear into the correct spot.
I hope you like this motor box and the whole Mini Train series.
If you want to support me, you can simply follow, boost & like the model.
You want to sell printed parts from my designs? Commercial license you get at my Makerworld profile or on Patreon:
BamBam Design
