Panda Touch Desk Stand - 30 Degree Tilt - Minimalist Design

This design takes approximately 33 mins to print and only uses 15g of material

I received my BTT Panda Touch and wanted it on my desk rather than on my P1S. There are a few designs out there for desk mounts, but I wanted something minimalistic that I could also print in a short time.

This design utilises the magnetic mount and screws that come with with the Panda Touch. So you can have it on the desk, or use the 30 min battery and take it with you (Still fully detectable).

I prefer the slightly laid down look and found it easier to see and use on my desk so opted for a 30 degree tilt, which felt better to use that a lot of the 45 degree ones out there. It also sits very nicely under the monitor on my desk this way.

There is a slot on the stand to hot glue the USB C cable into, should you wish (also holds without glue due to the curve in the cable).

There are 4, 8.5mm x 1mm recesses on the bottom of the design, so that you can install up to 8 x 2.5mm rubber feet to stop any slipping (should you wish).

Example, if you buy from Amazon: 8mm x 2.5mm Clear Bump / Slip Pads (These can be used for other projects, etc…)

Please give feedback and happy printing…