Ninebot G3 Bearing covers

It is a well-known problem that the bearings of this model of scooter are not protected from water. That is why I created these covers. The covers need to be glued with a sealant. I would not recommend silicone for this. Before gluing, you need to degrease. The cavities of the rear wheel should be lubricated with bearing grease or solidol. I recommend using a syringe without a needle. The front wheel is lubricated when the glue is completely dry. The grease creates an additional barrier against water ingress. But this does not mean that it will be possible to ride through puddles that will cover the bearings. This is only protection against dirt and rain.

Boost MeIt's absolutely free to boost this model and is an amazing way to support my design work!
Your boost is greatly appreciated and please leave a comment showing off your print and leave some feedback too about my designs, or any future ideas for designs you may have.