DJI O4 Air Unit Pro Antenna Protector

DJI O4 Air Unit Pro Antenna Protector
 

Product Description
 

Available in two versions: Max Protection and Light.
Print time on a P1S is approximately 17 minutes.
Weight: 2 grams for the Max version and 1 gram for the Light version (for two protectors).
 

The antennas on the DJI O4 Air Unit Pro are vulnerable to damage, especially during impacts or rough landings. This antenna protector is designed to provide solid protection for the delicate antenna ends, preventing damage during accidental bumps. With this, your DJI O4 Air Unit Pro will get an extra layer of protection without compromising signal quality.
 

Material & Durability
 

The protector is printed in PLA, offering enough durability and resistance to minor impacts. However, you can print it using any filament you prefer. It’s perfect for daily use, providing long-lasting protection. The Light version is lighter and easier to print, but if you experience adhesion issues on your print bed, using a brim will help with stability.
 

Installation
 

Installing the protector is super simple: just slide it onto the antennas until you hear a satisfying "click." The protection is stable and effective, and removal is just as easy – gently press from the bottom with your thumb and slide it off. Keep in mind that after removing and reattaching it several times, the "click" might not be as strong, so it’s best to install the protector once and leave it in place.
 

Recommendations
 

Light Version: For the Light version, make sure your print bed is properly prepared. If you have trouble with adhesion, using a brim will help ensure a stable print.
 

Support
 

If this product meets your expectations, I’d really appreciate your support through rating and downloading the model. Your feedback helps me create new projects and improve products for the entire MakerWorld community!