LSI 9300-16i HBA Cooling Fan Shroud

This is only a print profile from for a fan adapter for a LSI 9300 16i SATA/SAS controller.

The design is from briancmoses on printables, please see link below!
Thanks for your work.

Source:

https://www.printables.com/model/1046107-lsi-9300-16i-hba-cooling-fan-shroud

Here is the original description for the maker on printables:

The LSI 9300-16i HBA is a wonderful choice for DIY NAS enthusiasts,  but outside of data center with frigid climate control and numerous fans pushing air over its heatsink,  it tends to get warm.

This shroud clips around the LSI 9300-16i's heatsink and adequately cools the HBA by pushing air across the heat stink.  There are STLs for four different fan sizes:

1. 92mm x 92mm x 15mm
2. 92mm x 92mm x 25mm
3. 80mm x 80mm x 15mm
4. 80mm x 80mm x 25mm

The fan shroud clips to the HBA's heatsink and are positioned in a way that they do not interfere with any of the components on the HBA's circuit board.  

Don't have a 3D-printer? 

• Cooling Shroud Kit for a LSI 9300-16i on eBay
• Cooling Fan Shroud for a LSI 9300-16i on eBay

Slicing/Printing Tips:

• Enable supports
• Set perimeters/walls to 4
• Recommended filament: PETG
• Tested filaments: PLA, TPU

Installation Tips:

• Route the fans connector through the shroud's hole before installing the fan.
• Position the fan so it is pushing air towards the heatsink.
• The shroud fits pretty snugly on the heatsink, it may be necessary bend the legs of the clip to get them all to clip onto the heatsink.
• Depending on the size of the fan, plan on the shroud blocking at least one PCIe slot.
• Install the shroud so that the cable is coming out the right side of the HBA (near the SFF-8643 connectors)

Suggested fans:

• Noctua NF-A9x14
• Thermalright TL-9015
• Thermalright TL-8015
• Use a different fan?  Share it in the comments to get it added to the list!
   

Credit:

While I designed this from scratch in OpenSCAD,  it was was greatly inspired by the LSI 9300-16i Noctua NF-A9x14 Fan Shroud and made a few tweaks to meet my needs:

• Fewer 90 degree edges, hopefully for easier 3D-printing.
• Added support for additional fans.
• Reinforcement on the each of the legs to increase durability.

Many thanks to BlackHornet for their design!