Snap In Wall Hanger for Pipes

Original design was for the 75mm pipe hanger that I designed and printed to hang my BMW Overpipe (~7-10lb) in my garage bathroom as a display piece which have been holding strong for over a year and was printed with basic PLA. This hangers are designed specifically to hold pipes that have irregular shapes and curves. The hangers have a bit of flex in them so you can push the pipes in and they can snap around the pipe. The Hangers are designed to face up so the weight of the pipe pushes the pipe down into the hanger and can't fall out overtime as the filament begins to stretch, so there is a right and wrong way to install them, make sure to double check that when installing. Other variants of this hangers (34, 50, 67.5 mm) have not been tested so use at your own risk.

The model can be printed without any supports. Its designed for use with screws that you have to screw into the wall or another surface where you are trying to secure the hangers to.