Phone Holder Adapter - Fiat Punto EVO (Blue&Me Socket)
This adapter allows you to mount a modern smartphone holder in the original dashboard socket reserved for the old TomTom Blue&Me navigation systems on the Fiat Punto EVO (and similar models like the Punto 2012).
It is designed to fit perfectly into the proprietary dashboard port, ensuring a solid and vibration-free grip without needing suction cups on the windshield or clips on the air vents.
🇬🇧 Features
- Direct Fit: Slots directly into the dashboard's "Blue&Me" port (top center).
- Ball Joint Compatibility: Designed to work with standard 17mm ball joint phone holders (very common standard).
- Sturdy Design: Engineered to handle road vibrations and keep the phone stable.
- Clean Look: Maintains the dashboard's aesthetics without wires hanging across the steering wheel.
🇮🇹 Caratteristiche
- Montaggio Diretto: Si inserisce direttamente nella predisposizione "Blue&Me" originale sul cruscotto (al centro sopra le bocchette).
- Compatibilità a Sfera: Progettato per supporti telefono con attacco a sfera standard da 17mm.
- Grande Tenuta: Disegnato per resistere alle vibrazioni della strada e mantenere il telefono stabile.
- Design Pulito: Mantiene l'estetica del cruscotto senza ventose sul vetro o clip che bloccano l'aria condizionata.
📱 Hardware Compatibility / Compatibilità Hardware - This model acts as a base adapter. You will need a commercial phone gripper/magnet to attach to the ball joint.
- Tested with / Testato con:
- Lamicall MagSafe Car Mount (Model referenced in photos)
- Amazon Link: https://www.amazon.it/-/en/dp/B0C4NGG4QG
Note: Any phone holder with a standard tightening nut and socket for a 17mm ball should work.
⚙️ Printing Settings / Impostazioni di Stampa
- Material: PETG, ASA, or ABS recommended (PLA may warp in a hot car during summer).
- Consiglio PETG, ASA o ABS per evitare che si deformi col calore estivo.
- Infill: 15% - 30% (Gyroid or Grid) for strength.
- Walls/Perimeters: 3 or 4 walls for the ball joint stem to ensure it doesn't snap under tension.
Supports: [Insert your specific recommendation, usually "Tree supports needed for the locking tabs" or "No supports needed if printed upside down"].
🔧 Installation / Installazione
- Push the adapter into the dashboard socket until it clicks/seats firmly.
- Unscrew the nut from your commercial phone holder.
- Place the nut over the 3D printed ball.
- Snap the phone holder onto the ball.
- Tighten the nut.
DanyDeggio
