V8 Engine Cooler

After posing my V6 Engine Cooler, I had many people wanting a V8 Engine Block Cooler. This V8 cooler is sliced for P1 and X1 printers sonly. I labeled the plates for easy orientation during install and print. The duel color is set after slicing and I placed a color change in the file so it saves time in print and same across the board once you assemble. Change the color combo to your preference.

Support is needed

I only use support interface on the top lid. The rest was not needed and it saved time.

Note: because I sliced it to build the cooler, I used a Gorilla rubber type glue to seal all the seams so it wont leak when you put Ice in it. Due to the very tight tolerance of the lid, I pre-shrunk it to 99.8 percent so its easier to put the lid on. For some reason it shows up as 100% after doing this, so if you want to put it back to original size, just put it 100.02% but it will be very tight.

My V6 Version: https://makerworld.com/en/models/211857#profileId-231643

Koozie: https://makerworld.com/en/models/411911#profileId-313818