Oversized Lollipop Container

This is an oversized lollipop container. It print's in two halves. One half also has the stick and uses AMS. However I also have a print profile where a pause is added in so you can switch the filament to white. This model takes a little more than 120 grams of filament and about 5 hours to print. And it does use supports but it shouldn't be too hard to remove them. After printing and taking off supports press the 2 pieces together and your good to go. Of course this isn't super practical storage-wise but it's a fun idea. And maybe you could do something like putting normal sized lollipops inside. The possibilities are endless. As always, let me know if you have any questions, comments, concerns, etc.

 

Enjoy,

LeopardGeckoGuy

 

Update 1:

Due to request I have added a Non-AMS version.

Boost MeLike this model? A boost goes a long way to help me out!