DJI Action 2 GEPRC Vapor Mount

Remix of ScreaminFPV's DJI Action 2 Diamond Mount for the GEPRC Vapor Drones

Link to ScreaminFPV Base model

Please refer to the link above for ScreaminFPV's Diamond Mount features and previews for Camera views & angles w/wo ND Filters

Model Uploaded is 25 Degrees tilt, if needed i can modify by comment/chat request (I used Bambu Lab TPU 90A)

The rear M3 screws are slightly recessed and require a bit of flex in the TPU Pre mount to installation 

Because of the tight clearance at the back of the mount, the easiest way to install the back two screws are to Place the screw onto the tip of an Allen driver and then Carefully wedge the screw into position from the Side or Rear

The screw channels pass through the bottom layer of the mount, allowing you to insert an Allen key from above to fully tighten the screws once they are started.

This design keeps the mount rigid and short