YoRHa No. 2 Type B aka 2B - Nier Automata

YoRHa No. 2 Type B aka 2B – Nier: Automata

Like all models, this model is separated into different parts and put together with connectors. This allows you to print them in large sizes even with an A1 Mini. Additionally, if a print fails, you don't waste too much time or filament.
I try to position the cuts so that there are minimal visible support structures left.
If you feel the connectors are too tight or too loose, you can simply upscale them in BambuLab Studio for a better fit. Don't use too much glue when glueing together!
 

The total height of the figure in my print profile is about 26 cm. I don't recommend to print it smaller.

Head:

2 Head options: With and without eyecover.

Head position & rotation: I printed the version with the rotated head, so I recommend to use the one on the right. I added the left one just to provide a rotation where the surfe is parallel to the print bed.

Arms:

2 Arm options: With and without feathers.
You can print the one with feathers, but be aware that those feathers are quite thin. Be careful!
The arm options with separate feathers was more an experiment. I'd rather have this option included and don't need it, than the other way around.

Recommendations:
Get some tools like a scalpel and an engraver, there are small ones in pen size, to get rid of residual support structures.

Important Note!
This print may includes small and fragile details (esp. hair and fingers). It printed fine on my tests with my setup, but your results may differ.
Please print at your own risk and adjust supports/settings as needed, especially if you have limited experience with delicate prints.
If you experience any problems, try experimenting with support structure settings and layer height.

Transparency
I am not the creator of the original model (orig. Mokujinh)
My work included posing and editing to make a printable model.