Giant Wing Dragon 350%

i wanted to print a very large dragon so i made this one !

I hope you enjoy it !

Assembly images Below!

1. Start with the Head & Head Ring

  2. Slide Head Ring into loop with flat side down and connecting dove tail outward.

    3. Slide Head Ring dove tail into Front Legs connecter

3A. Should look like this.

4. Grab Inner Left Wing, Left Wing Pin and Outer Left Wing.

4A. Take Inner Left Wing and insert Left Wing Pin, do not push pin all the way yet until Outer Left Wing hole is aligned with pin. Once aligned Insert Pin all the way though Outer Left Wing.

5. Should look like this once complete — (Repeat step 4,4A and 5 for Right Wing)

 6. Grab Complete Right Wing, Body Wing and Body Wing Ring.

  7. Slide Right Wing Ring through Body Wing as shown ( Pay close attention to the connecting angle of Right Wing Ring)

8. Slide Right Wing Ring dove tail into Right Wing connection. 

  8A. Should look like this when complete. (repeat steps 6,7,8 and 8A for Left Wing)

  9. Body Wing and Wings should look like this when complete.

  10. Connect Head & Front Legs to Body Wing & Wings Parts using the Front Legs Ring.

  10A. Should look like this when complete.

   11. Connect Rear Legs to Wing Body using Wing Body Ring.

  11A. Should look like this when complete.

  12. Grab Rear Legs, Rear Tail 1 & Rear Legs Ring.

  12A. Connect Rear Legs with Rear Tail 1 using Rear Legs Ring.

  12B. Should look like this when complete.

13. Connect Rear Tail 1 to Rear Tail 2 using Rear Tail 1 Ring.

  13A Should look like this when complete.

  14. Congratulation ! You have built the Giant Wing Dragon ! Enjoy and Thank You For Your Support !!