Marlboro Red Decorative Vase

Boost MeI don't even smoke lol

A LARGE pack of Marlboros to use as a nice flower vase (:

 

I designed this model to be the most print / waste optimized as possible!

it prints out in four pieces that need to be Superglued when finished!

The faceplate & the top text piece print upside down to retain as much detail in the logo as possible, these can be flipped in your slicer if you would rather them be the top finish.

A non textured smooth plate is recommended to keep a consistent finish around the model, however is not needed! 

 

Glue the faceplate to the thin side of the main body piece first, as the top will then sit flush with everything making the lineup process much easier!

 

MAJOR UPDATE!!!!

I really wanted to make this model waterproof in someway or another, so it cold hold living flowers, or plants.

After pondering for a few days i came up with the idea to make a GIANT cigarette propagation tube insert.

This piece simply, and satisfyingly slides into the existing vase and allows you to propagate your plants.

It also looks like the worlds widest / largest cigarette in existence.

This piece will be uploaded as a separate profile, The propagation tubes i used were 165mm x 30.6mm anything around that range or slightly smaller should workout just fine!

 

If you enjoy my model please give me a boost!

Thank you!

-K0nur