Wardrobe bar holder/bracket (parametric, 2 screws)

Wardrobe bar holder/bracket with two countersunk screw holes.

In the profile there are models for 20mm, 22mm, or 25mm bar diameter. (Important note: the default profile is for wooden bars where the diameter is usually smaller than nominal amount; use 0.4mm clearance for metal bars!)

The models has small clip, that clicks the bar in place (inserted from above).

 

The model is fully configurable:

• diameter of the bar/rod,
• clearance for the diameter (0.4mm for loose fit for accurately sized bar/rod measured with callipers),
• screw size (accepts 3.5mm, 4.0mm, 4.5mm, and 5.0mm; the clearance is calculated automatically),
• brim width,
• “clip width” for the mechanical lock for the rod (default is 0.5mm for secure click),
• base thickness (default is 4.0mm; you can add more thickness to dial down horizontal fit of the bar),
• support bracket length (this extends the support bracket for more secure width).

 

If you are afraid that the model might break under the weight, I suggest increasing “brim width" and “support bracket length”. This increases the strength the most. Also, print in “strength" print profile (6 wall loops and 25% infill density) for maximum strength.

 

Cut the final bar/rod to the closet width  –  2 × base thickness (by default 4mm); so: closet width – 8mm by default.

 

 

 

Boost Me

 

 

 

Check my other wardrobe bar holder/bracket models:

• One screw:  https://makerworld.com/en/models/2699470-wardrobe-bar-holder-bracket-parametric
  
   

• Three screws:  https://makerworld.com/en/models/2699840-wardrobe-bar-holder-bracket-parametric

   

• Three holes; through hole for bar (you can cut the bar to the exact closet width):  https://makerworld.com/en/models/2829597-wardrobe-bar-holder-parametric-3-screws-b