Parametric Power Strip Holder

Boost MeBoost me to help me create more models !!

 

Parametric holder for mounting power strips under a desk, on a wall, workbench, panel, or furniture surface. The design grips the power strip from the upper side edges, leaving the bottom open to save material and make installation easier.

The model includes multiple parts for different use cases:

• Part A: cable-end holder with adjustable cable opening.
• Part B: open middle support, split into two independent side pieces (print this one only if you need it).
• Part C: closed-end holder.

Use A + C to hold a power strip at both ends, or add the B parts in the middle for longer power strips or extra support.

You can use just 2 B parts to hold the power strip just in the middle part.

 

Features

• Fully parametric design.
• Open-bottom structure.
• Upper retaining lips to hold the power strip.
• Mounting tabs with screw holes.
• Adjustable cable opening on Part A.
• Optional middle support parts.

Main Parameters

• Part length.
• Power strip width.
• Side clearance.
• Wall height.
• Wall thickness.
• Top lip size.
• Screw hole diameter.
• Counterbore diameter and depth.
• Cable opening width and height.

Recommended Use

1. Measure your power strip width.
2. Adjust the width and clearance parameters.
3. Print Part A for the cable side.
4. Print Part C for the opposite end.
5. For extra support, print both Part B side pieces and place them in the middle.

Suggested Print Settings

• Material: PLA, PETG, ABS, or ASA.
• Layer height: 0.20 mm.
• Walls/perimeters: 3 or more.
• Infill: 20-35%.
• Supports: usually not required.
• Orientation: print with the mounting tabs flat on the bed.

Notes
Before printing a full set, print a short test piece to check the fit. Adjust clearance depending on your printer, material, and power strip shape.