Rear Light Adapter for Cube Reaction Hybrid

Rear Light Adapter for Cube Reaction Hybrid

This adapter allows you to mount a rear light neatly and discreetly on a Cube Reaction Hybrid bike.

The adapter uses the existing threaded mounting point on the frame, so no additional clamp around the frame is needed. The rear light can then be attached to the adapter using an M5 screw and nut.

This creates a clean and elegant installation, while allowing the light cable to be routed together with the brake hose toward the motor area.

Features

• Designed for the Cube Reaction Hybrid
• Uses the existing threaded frame mount
• Clean and discreet rear light installation
• Allows tidy cable routing along the brake hose
• Compact 3D-printable adapter
• No bulky frame clamp required

Required Hardware

• 1x M5 screw
• 1x M5 nut
• Screw for mounting the adapter to the threaded frame mount
  (length/type depends on your bike setup)

Compatibility

This adapter was designed and tested for a Cube Reaction Hybrid.

It may also fit other Cube models with a similar frame and mounting point, but I have not tested this. Please check the dimensions and mounting position before printing or installing.

The picture shows this adapter with the Litemove Tail light “TSV”

Installation Notes

Mount the adapter to the existing threaded mount on the frame.
Then attach the rear light to the adapter using an M5 screw and nut.

Before riding, make sure the adapter, screw connection, and rear light are firmly secured and that nothing interferes with the brake rotor, wheel, spokes, or suspension movement.