Toro Grandstand Stand on mower

 

Toro Grandstand ZT Mower NO AMS on 2 plates.  This is a Stand on mower. The wheels roll freely and the swivel pivots for zero turning, no glue needed all push pin assembly. The Mower measures about 5 inches long x 4 inches wide x 3.25 inches tall. I used all PLA and printed on a P1S with support and brim on. I hand painted the raised lettering, but I am not good at it. a little to shaky. 😒

 Assembly, how I do it 

1. Remove all support first, clean out any holes. 
2. Do any painting 
3. Push the pins into rear wheels on the hubs, put hubs on to frame and add stand on platform
4. Assemble the wheels and pins in the front yokes and attach the yokes to frame  
5. Place gas cap on to tank add tank to control box
6. Add knee pad to control box
7. Put control box on to frame and add handle bar 
8. Attach the engine, and mower deck
 Have Fun
 

Boost MeIf you like my model say it with a Boost and PLEASE don't for get to rate it, leave comments and post pictures. I love seeing your prints. 😎 It also helps you get tokens.