FITS COMMON KIDS WOODEN TRACK (20mm between wheels)
WORKS WITH THOMAS WOOD SERIES, TAKE ALONG, AND TAKE N PLAY SETS
MATCHING CART/TRUCK
A three piece, snap-together, print-in-place toy steam train with moving wheels, and moving side-rods and built in supports with complementing cart. Based on the LBSCR E2 Class with extended side tanks from 1916 of which Thomas the Tank Engine from “The Railway Series” Books by Rev. W. Awdry and “Thomas and Friends” TV Show, is based upon.
BILL OF MATERIALS:
PRINT LIST:
TOP, QTY = 1
BOTTOM LEFT, QTY = 1
BOTTOM RIGHT, QTY = 1
CART HALVES, QTY=2
SNAP CLIPS, QTY = 6
ADDITIONAL HARDWARE:
5x3mm MAGNETS, QTY = 4 (OPTIONAL)
INSTRUCTIONS:
Print all pieces. Careful when removing the snap clips.
Gently remove supports by applying horizontal pressure just where the support meets the part. If you experience resistance, use a sharp knife to carefully separate the join.
Apply careful rotating force to release the wheels. Wheel will continue to loosen with use.
Use snap clips to connect the two bottom halves (right and left) together. Insert the clips firmly until a snap can be heard.
Finally, connect the bottom half to the top with the remaining clips.
(Optional) Use a light application of epoxy with 5x3mm round neodymian magnets. Be sure to orient the magnets correctly before affixing. (ie. make sure the magnets are flipped the correct direction to attract and not repel other toys).
Enjoy!
0.4mm nozzle
0.2mm Layer Height
No Supports (except built in wheel supports of course which break away with ease!)
Brim not required (for most materials)
Generally standard settings
Train Size: 77mm x 33mm x 50mm (LxWxH) (20mm between wheels)
Printed on the Bambu Labs X1 Carbon with AMS with eSun & Hatchbox PLA+
robert.stevenson
