Mechanical Carpenter Pencil

No need to waste money on expensive mechanical pencil, when you can print a fully printable mechanical carpenter pencil.

Uses 2.8mm lead.

Might be a little rough at first due to layer lines, but you can sand the bottom side of the button/pencil holder assembly and/or add some grease. I personaly just played with it till it became smooth by just sliding the button up and down.

Layer height: 0.20

Walls: 4

Bottom n top: 5

Infill: 15 % Gyroid

Support: Only for Button( Pencil holder assembly)

Brim: Yes