UHS - Ultimate Spool Holder - 4in1 PTFE

Description

I needed an improvement from my old spool holder which was too far back for convivence. I was looking into convenient side spool holder for my printer. Unfortunately nothing I found really strike me as what I wanted until I saw this where it utilized AMS lite parts, however it did have some design choices which I did not like so I made my own version.

MAIN FEATURES:

• Side spool for easy access
• Utilizes AMS spool holder
• Utilizes 4 in 1 PTFE adapter
• Utilizes original PTFE connctor so you do not need anything from AliExpress
• Sturdy
• Smooth filament feeding
• No supports, easy print and assembly

WHAT DO YOU NEED:

1. AMS Lite Spool holder (Green) from BambuLab store - link
2. PTFE tube connector - you should have it, because it came with the printer, but if you dont, you can again buy from Bambu - link
3. PTFE tube, you should have plenty, but anyhow… link
4. 4in1 PTFE tube - I integrated mount for it into the design. But strictly speaking you can skip it if you like - link
5. M5x25mm internal hex + washer (optional but recommended) - 1 pcs
6. M3x16mm internal hex - 4 pcs
7. M3x12mm internal hex - 1 pcs

ASSEMBLY:

Assemble shaft for AMS Lite spool holder as shown below. Then slide in the AMS Lite spool holder.

Snap in PTFE tube connector.

Mount it with 3 bolts to the back.

Place there 4in1 PTFE tube bracket and screw it with 4th bolt.

Connect 4in1 PTFE Adapter to the PTFE tube and screw it to the spool holder.

Add PTFE tubes and you are good to go.