BETA: Vault-Tec Pip-Boy Ultra for Apple Watch

By popular demand, a fully redesigned Pip-Boy for your Apple Watch Ultra 2! I plan to make more variations of this design to fit other Apple Watches, Galaxy, and Fit Bit as time permits. :)

EDIT: 5/29, working on updated model based on @Snorly providing some awesome feedback and measurements.

!!! NOTICE: This is a BETA version of this model since I have not had the opportunity to personally fit this print to an Apple Watch Ultra 2. The design is based on a scale model of an Ultra 2, so it should work, but I need community support to fine tune it if needed. Please print this model knowing it needs some real world feedback from you :)

Assembly Instructions:

1. Print the parts using the 0.2mm or 0.4mm nozzle print profile.
2. The 0.4mm print profile includes brims around the small knob and buttons for better bed adhesion, so peel those off.
3. Remove the supports around the watch face.
4. The top right hand print-in-place dial has a couple supports that are small and need to be removed. The dial can be tricky to break loose, but patiently work the dial back and forth until it begins to spin freely.
5. Holding the Pip-Boy watch face upside down, insert the buttons.
6. Gently install your watch with the single button side first, followed by pushing the other side of the watch into place.
7. Turn the watch right side up.
8. Install the bottom right knob by inserting it into the hole and turning clock-wise until it's firmly in place.