Adapter for Dewalt router to use in Festool

The model has been tested in ABS and PLA.

The suggested print settings are:

• 0.2 layer hight
• 60% infill
• 3-4 layers
• 5 bottom and top

Print orientation - vertical - would save you support and issues with fitting.

@edit

Both files have been edited and changed.

• The hole for the screw has been reduced.
• The fillet changed for the chamfer (45 degrees).
• Pointers were added at each end.
• Space for the M5 nut has been enlarged so there is around 2mm clearance between the Festool rail and the nut.

The screw for the handle is M5x20 

Bear in mind that the model has very small tolerances so make sure your printer is well tuned.