Fall 2

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

 

The Model is 200x200mm in size. You can change X and Y but Z must remain the same.
You may print at higher layer heights below the Min Depth of 0.48mm
Actual Depth is 2.3mm

 

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Red Transmission Distance: 4
PLA BambuLab Basic Orange Transmission Distance: 5
PLA BambuLab Basic Yellow Transmission Distance: 6
PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 5 unique filaments. Substitute as needed.

 

Swap Instructions:
Start with Black
At layer #6 (0.56mm) swap to Red
At layer #20 (1.68mm) swap to Orange
At layer #22 (1.84mm) swap to Yellow
At layer #24 (2mm) swap to Jade White for the rest.
 

Boost MeGot a Boost to spare? Every little bit helps the motivation. Thank you!

MembershipWant to go commercial or maybe just show some love? Consider signing up to show support!