Train station lamp M1:22,5 M1:24

The model is designed in scale 1:22.5–1:24 and is suitable for garden railways.

Station lamp model. Attention! Manual skill is required to complete the lamp! Also basic knowledge of electronics.
The lamp was printed from ASA material -I haven't tried PETG, but I believe it will print without problems. The cover glass is made of PETG material. If you use a good material for printing, it is possible to choose a layer thickness of 0.12 mm. For lamp printing always use: Brim.
Edges need to be trimmed/cleaned after printing is complete. Watch the assembly and gluing procedure on the video. The basic wiring diagram is shown in the picture. If you have a different voltage, you need to change the value of the resistor. If you don't know how to connect, write to me.

Adjust the number of parts to print as needed. In the printing profile, printing of all parts for two types of lamps is set.

Necessary accessories (Use similar parts):
 

LED 5mm warm white 8500mcD, 3100K, 8500mcd, 20mA, 3,1V (type)

Socket 2.54mm Pitch (type)

cables AWG 22 or smaller (type)