Parkside PPWD 30 A1 Vaccum Eurobox Cyclone

Clip in Eurobox Cyclone for Parkside PPWD 30 A1.

Eurobox used: 1a-TopStore Design Eurobox 40x30x18 cm. Foam seal needs to be added to the lid.
https://www.1a-topstore.eu/?a=5642&lang=eng

Depending on the planned project, a higher box could be a better fit.

The printed Euro_Box_Support parts are needed so that the vacuum will not deform the box and create a vacuum leak.

Original hose connectors need to be disassembled to fit 3D printed adapters.

Hose with an inner diameter of 38mm needed and a minimum length of 1.5m.

This cyclone is a remix of: https://www.thingiverse.com/thing:5579910
For assembly, see original cyclone.

All connectors are osVAC neo for a 38mm Hose. See https://www.thingiverse.com/thing:5253018 for more information.

----------------------------------------------------------------------------------------------------------------

Following parts need to be printed twice:

Cyclone_Lid_Support_outerside.stl
Cyclone_Lid_Support_innerside.stl
Euro_Box_Support_1.stl
Euro_Box_Support_2.stl
Cyclone_Box_Connector.stl (for assembly, mark middel of box and aligning with small notch on part)

----------------------------------------------------------------------------------------------------------------

The following parts are optional only if you want to use OsVAC connector on the end of the vacume hose:

Parkside_Hose_Connector_3.stl
Parkside_Hose_Connector_OsVAC_to_Nozzle.stl

-----------------------------------------------------------------------------------------------------------------

Tolerances changed for the newer PPWD 30 B2. So a different (slightly smaller) Cyclone Box Connector is needed.

https://makerworld.com/de/models/1153501#profileId-1158096