DeWalt Tough Case System Ikea Skadis Holder

DeWalt ToughCase+ Ikea Skadis Mount. Has a little latch at the top to clip it into place and release it. I use it with DT70723-QZ. Uses 3 M3x10mm Screws. I used simple washers and nuts to secure on the other side. I recommend a wide washer - at least 7-8mm. I just used M4 washers as they were larger and I had them available.

 

I highly recommend printing in PETG as PLA may not be flexible enough or snap.

Boost MeBoost me if this was helpful for your Skadis Board