Xtool S1 Power supply mount

An under desk mount for the Xtool S1 power supply.

The 2 pieces slide on from the sides and need to be pushed over the small feet of the power supply so that it can't fall out.

It attaches to the table with 3mm screws. (note, don't tighten the screws too hard so that the printed mount does not split)

The design has a 16mm gab from power supply to table to not trap heat of the power supply.

I printed the mount out of PLA, but PETG would be a better choice of material because it needs a bit of flex to get over the feet of the power supply.

Also Print with 4 layers wall thickness for optimal strength.