PAVO PICO - PAVO20 - DJI O4 AIR UNIT CANOPY

 PAVO PICO - PAVO20 - DJI O4 AIR UNIT CANOPY (no aditionnal pat needed)

ASA-CF USED, WORK WITH ANY HEATPROOF MATERIAL (PETG-CF, PETG ETC…)

Canopy for the Pavo Pico compatible with the new DJI O4 air unit (lite version).

Total weight with 2S lipo 550Mah : 79g
Total drone weight : 47g

Design made to perfectly fit in the Pavo Pico  (and the Pavo 20) with original screws and rubber pads.

Two parts :

- Bottom part for the O4 + Camera + anti-vibration pads
- Top part that clip on the bootom part for antenna + protection and easy air flow

Made for easy Air Flow, compatibility and lightweight. Only compatible with new DJI O4 Air Unit + Camera. Easy access to Type-C, boot / reset switch.

List of material needed :
-4x Canopy screw (Optionnal if Light weight)
-4x Rubber pads (in o4 box or pavo pico spare parts)
-4x Long plate screw with nuts (Those screws will both fix canopy + o4 + AIO board + crash Guard ) (Longgest screw you recieve with PAVO PICO or PAVO20 replacement parts)
-Screwdriver

Recommended Print :

No supports
0,16mm
2 Wall loop (lightest) (2,3 gram)
15% Infill (lightest) (2,3 gram)
ASA-CF (or any lightweight material + decent heatproof (PETG-CF, PETG). PLA may be too weak for +70°C O4 temperature.

If you have a TBS reciever or any other than ELRS, it can go at the same place.

PDF FILE INSCTRUCTION

Thanks !