Clicky Citrus Spinners (2-in-1 Fidget Toys)

You get twice the fun with these two-in-one fidgets: a rotating magnetic “ratchet” fidget and a spinning top 🙌

Important: You will need (8) 6mm x 3mm neodymium magnets for each fidget (4 magnets for each half of a fidget)

Here is an Amazon link to the magnets and filament I used: https://amzn.to/3XA7HkC

3D Print Settings for the Lemon & Lime Fidgets: 

• 0.2mm Layer Height 
• 25% Infill 
• Outer Wall Speed 100mm/s 
• No supports needed 
• Outer brim on ‘peg’ piece

I have also included a 3MF file with the following print profiles: 

• Print plate #1 (lemon fidget): 2 colors; pause added at layer 22 (layer height 4.40mm) to insert magnets (make sure to orientate the magnets correctly - see photo)
• Print plate #2 (lime fidget): 2 colors; pause added at layer 22 (layer height 4.40mm) to insert magnets (make sure to orientate the magnets correctly - see photo)

3D Print Settings for the Orange Fidget: 

• 0.2mm Layer Height 
• 25% Infill 
• Outer Wall Speed 100mm/s 
• No supports needed 
• Outer brim on ‘peg’ piece

I have also included a 3MF file with the following print profiles: 

• Print plate #1 (Orange bottom piece): 2 colors; pause added at layer 22 (layer height 4.40mm) to insert magnets (make sure to orientate the magnets correctly - see photo); variable layer height adjustment added at top of this piece (to help fidget spin better)
• Print plate #2 (Orange top piece): 3 colors; pause added at layer 22 (layer height 4.40mm) to insert magnets (make sure to orientate the magnets correctly - see photo)
• Print plate #3: peg piece, 1 color

To assemble insert peg into bottom of each fidget (this will be a snug fit). The top piece will fit easily over the peg so it can be removed on and off.

Have fun printing! 🍋🍊