Tamashii: Chronicle of Ascend, Card Dividers

I found these dividers for Tamashii on thingiverse made by PolyPusher: https://www.thingiverse.com/thing:6410249 however they were made for a 3MF printer and as such the titles could not be printed on my single filament printer.

Therefore this remix makes it possible to print these dividers with single filament. They are 0.5mm thicker to make them a little less bendy and also make them so you can get a good “mostly” hidden filament change in there.

Print at 0.2, start with your main colour and then change filament to the colour you want your text to be at layer 3 and then change back to your main colour at layer 6.

These inserts are intended to be used with Hextra's insert https://www.printables.com/model/816866-tamashii-chronicle-of-ascend-expansions-insert-gam/files and as such the enemies level 1 2 and 3 are shorter than the rest due to how that insert has enemies. If you want to print these without Hextra's insert then you should resize these 3 dividers to be 90mm tall to make them the same height as the rest of the dividers. The smaller card dividers are a tight fit.. How I addressed this was that i stopped the print after a single layer of the final colour, I have yet to upload this change to these files though because it would take time to do so, therefore i advise to do a layer change at 3 and 6 but then once layer 6 have finished printing, end the print.

Hextra's insert is for the miniatures version of the game, if you have the retail version I have posted a remix of their insert to adjust it to fit the retail or all in gameplay pledge box here https://www.printables.com/model/1019707-tamashii-chronicle-of-ascend-expansions-insert-all