Easy-to-Print N-Strike buffer tube adapter

This adapter was designed with two goals in mind: to have an acceptable sturdyness and to be easily printable. The compatibility has been checked with the stock for the Nexus Pro, the one for the DZ Pro MK3 and the Raider-style stock by Gemeneye.

Print Instructions

All pieces don't need supports and is highly recommended to print it with 5 perimeters. The Front piece is printed with the flat front side on the bed, the Rear piece with the back on the bed, the Catch has an obvious flat face that goes on the bed and the buffer tube need to be printed on the flat face at the top on the bed.

Hardware

For hardware you'll need 8 M3x20 cylinder head bolts and one spring. The spring can be anything with a diameter of 6mm or smaller and with a minimum length of 10mm.

Assembly Instructions

 Start with sliding the catch in the front piece with its flat face on the outside, then insert the spring in the catche's hole. Put the rear piece on the front one and screw the bolts in (Please, check the correct orientation of the front and rear pieces from the inside). To finish off screw in the buffer tube.

In the files is included the STEP file of only the the catch as a basis for future remixes.