Gated Shifter fidget

I printed “Status_Symbol_3d - Gearshift keychain”. Although it was a nice fidget, I wasn't satisfied with the action. 

So I decided to make my own version of a gear shifter fidget. I made it so there's a spring to return the shifter to the center and a mechanism to lock it in gear. The diameter of the fidget is made the same as a 330ml can, so it can fit in a cup holder. 

I have tested the Print in PLA and PETG. 

if printed in PLA; Leave it in neutral when storing. Otherwise, the spring could deform over time. and it would not spring back to the center.

The tolerances are 0.15mm if your printer can't print this you might have to do some fine-tuning on the finished print to make it operate smoothly

Hope you enjoy :)

Assembly:

See photo of each step

• Attach the “Link” to the “bottom” This requires a bit of force
• Then connect the “Lever” to the “Link”. This requires a bit of force
  (note that the flat side of the "Lever" should be on the side with the marking)
   
• Screw the "Lever assembly" into the Shell a bit further than flush so the screw hole is aligned
• Screw in the “Screw” to lock the "Lever assembly" and "Shell" together
   
• Insert the “Spring” into the "Shell" and align the notch on the “Spring” and “Shell” 
• Push on the “Spring” until you hear or feel the lock tabs snap in place
   
• Insert the “Latch” into the “Shell” and align the notch on the “Latch” and “Shell”
• Push on the “Latch” until you hear or feel the lock tabs snap in place
• Place the “Slider” on top of the “Latch” the part should slide freely and not get snatched on anything
• Connect the “Latch top” to the “Latch”. The “Lever” should now be able to lock in place on either side
   
• Snap the "Gated top" in place so the lever is centered
• Lastly place the “Gearknob” on top of the “Lever”

Edit: 

11/11 - 2024

I've extended the length of the runners on the “Latch” to give more clearance when going into 6th gear. 

I've added an Extended lever (10mm longer)