Escape Room 4 Digit Prop Lantern

this was designed for use with M3 and a few M5 machine screws/nuts. magnets and magnetic washers are also required if the panels are 3d printed rather than cut from steel.

Solution:

unscrew the top umbrella shaped piece

use it to rotate the captive disk below it so the arrow aligns with the mouse holes on the top's sides. push in the holes to lever out the magnetic panels.

one of each removed panel can be lined up with a captive panel to form a number. the dots on the bottom indicate the order these digits should be used in. 

there are only 4 digits but they can be arranged in any order.