Fidget Spinner Bearing Cap for 608 Bearings

First off, I want to give credit where credit is due! I came across a fantastic 608 bearing cap on Thingiverse. I found the cap cover, however, to be a little smaller than I liked so I used the connector but added a larger cap cover. I also adjusted the tolerances so that you should be able to press the caps together with your hand. However, if the pieces are too tight, you can use two pieces of wood to sandwich the caps then press down until they fit together properly.

Printing:

• Supports: None
• Infill: I recommend 100%
• Layer Height: I use .16 but .2 should work just fine.
• Material: PLA