May 20, 2025
Description
It's a simple spinner! You can slide, spin, shake and uhh… tilt? I don't know, I just wanted it to spin.
All you need is:
- a 3D Printer
- Filament of your choice (this was done in PLA)
- Super glue
Recommended settings:
- Infill: at least 20%, hexagon/tri-hexagon
- Layer height: 0.2mm (I printed with 0.12mm)
- Wall thickness: 1.2mm
- Supports touching plate, with the indents for the holders facing towards the plate
Assembly Instructions:
- Put Holder - Bottom on a table or flat surface
- Slide the Main Body onto Holder - Bottom
- Put super glue into the hole of Holder - Bottom and the shaft of Holder - Top (make sure that the glue does not leak onto Main Body)
- Insert Holder - Top into Holder - Bottom and wait for the glue to dry
Do not put your prints near a naked flames / candle else it will have that burn mark. Or do, I'm not your parent. (Just kidding please do not ever put your prints near any flames)
License:
Creative Commons — Attribution
BenIsRong
