May 2, 2025
Description
-Trigger pieces need to be glued together at both sides.
-Mechanical pencil spring should be glued to at least one side in the small holes at the bottom of the trigger or body.
-Mag release should be glued in place at the center of the spiral.
-Rotate the mag release clockwise before gluing to make it easier to put the PEZ dispenser in, counterclockwise to make it less likely to fall out while being thrown around.
*Since it is scaled to a PEZ dispenser, it will probably be small in your hands.
***!!DO NOT SHOOT INTO OWN MOUTH, OR AT VERY CLOSE DISTANCES!!, the recoil goes forward and it will hit you really hard in the face.***
Top of the PEZ dispenser needs to be modified to allow a big enough gap for the pusher
Recommended print orientations and support settings are shown in slicer image.
Minor bridge strings may occur on the pins where the trigger is placed, and on the overhangs inside the mag well above the “P”.
Happy printing :)
License:
Creative Commons — Attribution — Noncommercial
Wagadoogy
