April 23, 2025
Description
This is a remix of another persons design (R0j0Pr0). There are a few things needed to complete this print, and those extra (non-printable) items/resouces will be listed below, in the "Post Printing" section.
Resources
Some strong string
Hot glue/super glue
2 small magnets (5 x 3mm)
Instructions
First you will need to thread the string through the small hole on the right (see instruction picture below).
Second, you will need to glue the top and bottom and the top together, but make sure THE BLADE IS IN THE MIDDLE (see instruction picture below).
Third, you will need to glue the magnets into the hole on the shaft, and into the hole on the lever, as well (see instruction picture below).
Next, you will need to slide the lever onto the knob on the front of the shaft [This is going to be the hinge] (see instruction picture below).
After that, you will need to glue the hinge cover onto the smaller knob that is connected to the top of the bigger knob (see instruction picture below).
INSTRUCTIONS
NOTES =====Update-
I will post a picture/video when printed!
License:
Creative Commons — Attribution — Share Alike
The_SignGuy
